Programming Names; Deleting Individual Phone Numbers; Delete Names - DKS 1834 PC Programmable Installation & Owner's Manual

3.5.5 Programming Names

In this section, names will be programmed into the system. Names are referenced to a phone number by entering the directory
code that the person's phone number has been programmed to.
MNO MNO MNO MNO
1. Press
6 6 6 6
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the name will be assigned to (1, 2, 3 or 4 digits, section 3.5.1),
then press (beep).
3. Enter the residents name, one character at a time, press
characters, pressing
The LCD display will display each character after
Refer to 3.4.1 and 3.5 for reference to letters, spaces etc.
4. Press (beep) to enter the complete name.
The LCD display will go blank after
3. Repeat steps 2, 3, and 4 to enter additional names.
OPER OPER
5. Press together to end this programming sequence (beeeeeep).
0 0

3.5.6 Deleting Individual Phone Numbers

This programming sequence is used to delete a single phone number under a known directory code. Proceed to 3.5.7 to delete
the resident name after deleting the phone number.
OPER OPER SP SP
1. Press
0 0 1 1
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the phone number has been assigned to (1, 2, 3 or 4 digits,
section 3.5.1), then press
3. Press
4. Repeat steps 2 and 3 to delete additional phone numbers.
OPER OPER
5. Press together to end this programming sequence (beeeeeep).
0 0

3.5.7 Delete Names

This programming sequence is used to delete a resident name from the directory. These steps WILL NOT erase the resident
telephone number from the system. Go to section 3.5.6 above to delete the resident telephone number.
MNO MNO JKL JKL
1. Press
6 6 5 5
2. Use the A and Z buttons to locate the name that is to be erased on the LCD screen, then press
3. Repeat step 2 to erase additional names.
OPER OPER
4. Press together to end this programming sequence (beeeeeep).
0 0
1834-065-B-10-14
and enter your four-digit MASTER CODE
(beep) after each character until all characters have been entered.
has been pressed.
*
and enter your four-digit MASTER CODE
(beep).
, then press
and enter your four-digit MASTER CODE
? ? ? ? ? ?
(beep) after each character to enter it. Continue entering
is pressed.
*
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
? ?
(beep).
? ?
(beep).
? ?
(beep).
(beep).
37