Rs-232 Test; Automatic Hang-Up Options - DKS 1834 PC Programmable Installation & Owner's Manual

6.1.1 RS-232 Test

This test procedure will check the RS-232 hardware to determine a PASS or FAIL mode. You will need two short pieces of wire
to perform this test (jumpers). Connect the jumper wires as shown to the RS-232 terminal.
RS-232
DB-9 Pin
Plug
SP SP
PQRS PQRS
1. Press
1 1 7 7
2. Press (beep).
PASS - The LCD display will indicate: RS232 HARDWARE PASS. One long tone will be heard: (Beeeeeep).
FAIL - The LCD display will indicate RS232 HARDWARE FAIL. Two short tones and a long tone will be heard:
(Beep - Beep - Beeeeeep).
3. Remove the jumper wires from the terminal after performing this test.

6.1.2 Automatic Hang-up Options

This sequence will allow you to program different methods by which the telephone entry system will hang-up if a resident
denies a guest access by hanging up their telephone rather than pressing the "#" key to terminate the call.
Factory setting is 1, dial tone detect ON.
GHI GHI OPER OPER
1. Press
4 4 0 0
The LCD display will show: 0=N 1=DT 2=SIL 3=BTH.
0 – BOTH OFF. Unit hangs up after programmed strike time runs out.
1 – DIAL TONE detect ON. Unit hangs up after detecting 5-seconds of dial tone.
2 –SILENCE detect ON. Unit hands up after detecting 15-seconds of silence.
3 – BOTH ON.
2. Enter the hang-up option code _ (0, 1, 2 or 3), then press
OPER OPER
3. Press TOGETHER to end this programming sequence (beeeeeep).
0 0
1834-065-B-10-14
Red
Black
White
Brown
Green
Shield
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
RS-232 Terminal
The 6-pin terminal
can be removed
for easy wiring.
? ? ? ? ? ? ? ?
(beep).
? ? ? ? ? ? ? ?
(beep).
(beep).
49