Removal Of Reducing Gear - TGB Hornet 50 Service Manual

4-3-1 Disassembly of Engine:

( Removal of Reducing Gear)

11. Removal of Reducing Gear:
A. Drain the oil in the reducing
gear box.
¡ ·
The Drain Screw of Engine
has two designs, in the clutch
cover or under the crank case.
B. Unscrew the Fixed Screw lightly
and evenly by diagonal step.
C. Remove Gear Box Cover. Tap
with plastic hammer if it can not
be removed.
D. Remove the Drive Shaft (1) from
the Gear Box Cover.
E. Remove the Cir-clip (2) of Rear
Shaft.
F. Remove the Left Hand Washer (3)
of Idling Shaft.
G. Remove the Gear (4) of Rear Shaft.
H. Remove the Gear (5) of Idling
Shaft.
I. Remove the Right Hand Washer (6) of
Idling Shaft .
J. Hook the Right Hand Bearing (7) of
Drive Shaft with special tool
and remove the Bearing.
special Tool: GA5000051F12.
K. Remove the Oil Seal (8) of Drive
Shaft on the Gear Box Cover
with screw driver.
L. Remove the Left Hand Bearing (9)
of Drive Shaft on the Gear Box
Cover with special tool.
special Tool: GA5000051F20.
49