Notice For Disassembly Inspection - TGB Hornet 50 Service Manual

4-1 NOTICE FOR DISASSEMBLY lNSPECTION
1. In order to avoid mixing and loss of disassembled parts before reassembling, the
disassembled parts have to be arranged according to their function during the process.
2. The damage to Cover and Frame should be avoided while disassembling and assembling.
3. Remove the negative (-) terminal of Battery before working.
4. While reassembling, make sure that all parts are normal.
5. Specified oil should be adopted on turning and sliding parts.
Specified grease should also be applied on specified positions.
6. Dust, dirt and unusual particles should be avoided while reassembling.
7. When important revolving and reciprocating parts, such as Cylinder Head, Cylinder,
Piston, Piston-Ring, and Crank, have been replaced, the vehicle can not go for full speed
running immediately. Preliminary running should be applied below 4000 rpm within
20hour.
8 . While assembling, the main lip of oil seal should face inwards (oil chamber) and the
antidust sub-lip should face outwards.
Apply an even layer of specified grease onto the lip before it is pressed to its location with
balanced force by specified jigs.
9 . While pressing the bearing into the hole, apply balanced force to the outer ring of bearing
by specified jigs.
While pressing the bearing into the main shaft, apply balanced force to the inner ring of
bearing by specified jigs.
40