Inspection Of Electric Items; Notice For Inspection And Arrangement Of Electric Components; Removal And Inspection Of Ignition And Charging System; Inspection Of Ignition Coil And C.d.i. - TGB Hornet 50 Service Manual

4-5 INSPECTION OF ELECTRIC ITEMS

¡ ·

Notice for Inspection and Arrangement of Electric Components:

A. Use pocket tester for inspection and testing of electric parts.
B. The battery for Testing should be of full charging.
C. The setting of the position of Tester Range has to be performed accurately.
D. The value of electric testing will vary in accordance with the Tester and the
temperature, thus it should be an estimate value only.
4-5-l Removal and Inspection of
Ignition and Charging System
1. Ignition and Charging Circuit:
A. Figure 1 Circuit Description:
With regard to the generation
of the flywheel magneto :
a. CDI and HTcoil (ignition coil) are
adopted to control the ignition
and angle for high voltage parts :
b. Regulating rectifier is adopted
to supply and control lamp and
charging voltage for low
voltage parts.
B. Inspection of Ignition Coil and
C.D.I. :
a. C.D.I.(CAPACITOR DISCHARGE
IGNITION) bullet type terminal(1)
is for Flywheel Magneto's input,
red/black Wire is for ground
and white/blue Wire is for
output at terminal(2).
Ignition angle's standard is
15 ¢ X /4000 RPM
Ignition coil (Fig. 3)
testing range X 1 K £ [
Use electric tester to check
resistance value (Fig.3),must
fit to " 8K £ [ ¡ Ó 10 ¢ M "
75