Displaying The Armed Status - Multiple Partition User; Disarming - Multiple Partition User - Pyronix Matrix 424 User Manual

Matrix User Guide
Arming Partition 1
Leave the premises by the designated route.
Depending on the programming and arm mode used, you may be required to press a 'Push To Set' button
before the system will fully arm.
4.2.7 Displaying the Armed Status – Multiple Partition User
The LCD keypad will display armed partitions with a "&" symbol underneath the partition number, as shown
below.
4.2.8 Disarming – Multiple Partition User
This section describes how to disarm your system under various panel states.
No Alarm Condition
Enter you personal user code
Select the partition(s) to be disarmed by pressing the appropriate numeric button on the keypad:
or .
The symbol indicating the partition to disarm will turn off. Alternate presses of the same numeric key will turn the
corresponding segment on / off.
Once you have selected all the partition(s) to disarm, press the
disarm.
After an Alarm Condition
Enter you personal user code
If your code has been accepted you will hear a confirmation tone and the OK icon (y) will flash. All armed
partitions are displayed. At this point you can arm or disarm any partitions allocated to you. All partitions in
alarm will be flashing.
Select the partition(s) you wish to disarm and press the
mode.
Page 20
. The partitions that are currently armed will be displayed:
key to confirm them. The partition(s) will
.
key. The system will go into First To Alarm (FTA)
Arming Partitions 1 & 2
, ,
RINS915-2