Lcd Keypad; Arming - Single Partition User; Displaying The Armed Status - Single Partition User; Disarming - Single Partition User - Pyronix Matrix 424 User Manual

Matrix User Guide
4 . 2 L C D K e y p a d
4.2.1 Arming – Single Partition User
If all zones are closed the OK LED will be illuminated.
Otherwise use the &
The open zones will be displayed in order on the display:
Enter you personal user code
The partition will start arming in mode A and a repeated high tone counting the exit time will be emitted from the
keypad.
If a different Arm Mode is desired press
TIME/DATE
ARM MODE
Leave the premises by the designated route.
Depending on the programming and arm mode used, you may be required to press a 'Push To Set' button
before the system will fully arm.
4.2.2 Displaying the Armed Status – Single Partition User
Once the system is armed the LCD keypad will either display the time/date and the arm mode (A, B, C or D) or
it will just the time and date. This depends on how the Matrix features have been programmed by your installer.
4.2.3 Disarming – Single Partition User
Enter you personal user code
No Alarm Condition
If your code has been accepted, you will hear a confirmation tone and the system will disarm. The LCD keypad
will revert to normal day mode operation.
After Alarm Condition
If your code has been accepted, you will hear a confirmation tone and the system will go into First To Alarm
(FTA) mode.
Page 18
buttons to list the open zones.
to arm the panel.
then
B
.
or or or .
RINS915-2