D-Link DGS-3224TGR Command Line Interface Reference Manual page 69

config 802.1p default_priority
Purpose Used to configure the 802.1p default priority settings on the switch. If an untagged packet
is received by the switch, the priority configured with this command will be written to the
packet's priority field.
Syntax config 802.1p default_priority [<portlist>|all] <priority 0-7>
Description This command allows you to specify default priority handling of untagged packets received
by the switch. The priority value entered with this command will be used to determine
which of the eight hardware priority queues the packet is forwarded to.
<portlist> − Specifies a range of ports that will belong to the link aggregation group. That is,
Parameters
a range of ports for which all untagged packets received will be assigned the priority
specified below. The beginning and end of the port list range are seperated by a dash. For
example, 3 would specify port 3. 4 specifies port 4. 1-4 specifies all of the ports between
port 1 and port 4 − in numerical order.
all − Specifies that the command applies to all ports on the switch (or in the switch stack).
<priority 0-7> − The priority value you want to assign to untagged packets received by the
switch or a range of ports on the switch.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure 802.1p default priority:
show 802.1p default_priority
Used to display the current default priority settings on the switch.
Purpose
Syntax show 802.1p default_priority
Description This command is used to display the current default priority settings on the switch.
Parameters None.
None.
Restrictions
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
DGS-3224TGR:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DGS-3224TGR:4#
65