D-Link DGS-3224TGR Command Line Interface Reference Manual page 154

show authentication server_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view authentication server hosts currently set on the Switch:
DGS-3224TGR:4#show authentication server_host
Command: show authentication server_host
IP Address Protocol
---------------
10.53.13.94 TACACS
Total Entries : 1
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
Used to view a user-defined authentication server host.
show authentication server_host
This command is used to view user-defined authentication server
hosts previously created on the Switch.
The following parameters are displayed:
IP address – The IP address of the authentication server host.
Protocol – he protocol used by the server host. Possible results will
include TACACS, XTACACS, and TACACS+.
Port – The virtual port number on the server host. The default value is
49.
Timeout – The time in seconds the Switch will wait for the server host
to reply to an authentication request.
Retransmit – The value in the retransmit field denotes how many
times the device will resend an authentication request when the
TACACS server does not respond. This field is inoperable for the
tacacs+ protocol.
Key – Authentication key to be shared with a configured TACACS+
server only.
None.
Only administrator-level users can issue this command.
Port Timeout Retransmit Key
-------- ----- -------
49 5
--------------- --------
2 ------
150