D-Link DGS-3224TGR Command Line Interface Reference Manual page 50

config stp
Purpose Used to configure Bridge management parameters for STP on the switch.
Syntax config stp {maxage <value 6-40>|hellotime <value 1-10> |forwarddelay <value 4-
30>|priority <value 0-61440>|version [rstp|stp] |txholdcount <value 1-10>|fbpdu
[enabled|disabled]}
Description This command is used to setup the Spanning Tree Protocol (STP) for the entire switch.
Parameters maxage <value 6-40> − The maximum amount of time (in seconds) that the switch will wait
to receive a BPDU packet before reconfiguring STP. The default is 20 seconds.
hellotime <value 1-10> − The time interval between transmission of configuration messages
by the root device. The default is 2 seconds.
forwarddelay <value 4-30> − The maximum amount of time (in seconds) that the root device
will wait before changing states. The default is 15 seconds.
priority <value 0-61440> − A numerical value between 0 and 61,440 that is used in
determining the root device, root port, and designated port. The device with the highest
priority becomes the root device. The lower the numerical value, the higher the priority. The
default is 32,768.
version [rstp|stp] − Allows the selection of either Rapid Spanning Tree or regular STP.
fbpdu [enabled|disabled] − Allows the forwarding of STP BPDU packets from other network
devices when STP is disabled on the switch. The default is enabled.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To set maxage to 18 and hellotime to 4:
DGS-3224TGR:4#config stp maxage 18 hellotime 4
Command: config stp maxage 18 hellotime 4
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
46