D-Link DGS-3224TGR Command Line Interface Reference Manual page 44

show packet ports
Purpose Used to display statistics about the packets sent and received by the switch.
Syntax show packet ports <portlist>
This command is used to display statistics about packets sent and received by ports
Description
specified in the port list.
<portlist> − specifies a range of ports to be configured. The port list is specified by listing the
Parameters
beginning port number and the highest port number of the range. The beginning and end of
the port list range are separated by a dash. For example, 3 would specify port 3. 4 specifies
port 4. 3-4 specifies all of the ports between port 3 and port 4 − in numerical order.
Restrictions None.
Example Usage:
To display the packets analysis for port 7:
DGS-3224TGR:4# show packet ports 7
Command: show packet ports 7
Port number : 7
Frame Size
-----------------
64
65-127
128-255
256-511
512-1023
1024-1518
Unicast RX
Multicast RX 557
Broadcast RX 3686
Broadcast RX 4495
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
Frame Counts Frames/sec
------------------- ----------------
3275 10
755 10
316 1
145 0
15 0
0 0
152 1
2
16
42
Frame Type Total
----------------- ----------
RX Bytes 408973
RX Frames 4395
TX Bytes 7918
TX Frames 111
40
Total/sec
-------------
1657
19
178
2