D-Link DGS-3224TGR Command Line Interface Reference Manual page 111

config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax config radius delete <server_index 1-3>
The config radius delete command is used to delete a previously entered RADIUS server
Description
configuration.
<server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up to
Parameters
three groups of RADIUS server settings can be entered on the switch.
Only administrator-level users can issue this command.
Restrictions
Example Usage:
To delete previously configured RADIUS server communication settings:
config radius
Purpose Used to configure the switch's RADIUS settings.
Syntax config radius <server_index 1-3> {ipaddress <server_ip> {ipaddress <server_ip>|key
<passwd 32>|auth_port <udp_port_number 1-65535>|acct_port <udp_port_number 1-
65535>}
Description The config radius command is used to configure the switch's RADIUS settings.
Parameters <server_index 1-3> − Assigns a number to the current set of RADIUS server settings. Up to
three groups of RADIUS server settings can be entered on the switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between the switch and the
RADIUS server.
default − Returns all of the ports in the range to their default RADIUS settings.
auth_port <udp_port_number 1-65535> − The UDP port number for authentication requests.
The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for accounting requests.
The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure RADIUS settings:
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
config radius delete 1
DGS-3224TGR:4#
Command: config radius delete 1
Success.
DGS-3224TGR:4#
<passwd 32> − The shared-secret key used by the RADIUS server and the switch. Up to
32 characters can be used.
107