Network Management Commands - D-Link DGS-3224TGR Command Line Interface Reference Manual

N
ETWORK
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
create snmp
community
delete snmp
community
enable rmon
disable rmon
config snmp
system_contact
enable snmp traps
disable snmp
traps
enable snmp
authenticate traps
disable snmp
authenticate traps
show
trusted_hosts
ping
create snmp user
delete snmp user
create snmp view
delete snmp view
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
M
Parameters
<community_string 32> view <view_name>
[read_only|read_write]
<community_string>
<sw_contact>
<ipaddr>
<ipaddr>
times <value>
timeout <sec>
<username 32> <groupname 32> {encrypted(1) [by_password auth [md5
<auth_password 8-16> | sha(3) <auth_password 8-20>]
priv [none| des <priv_password 8-16>] | by_key auth [md5 <auth_key 32-32> | sha(3)
<auth_key 40-40>]
priv [none| des <priv_key 32-32>]]}
<username 32>
<view_name 32> [all | <oid>]
<view_name 32> <oid> view_type[included(1 | excluded)
ANAGEMENT
27
6
C
OMMANDS