Skew (Using Adf) - Lexmark X651de Service Manual

7462

Skew (using ADF)

Leading edge
Trailing edge
The printed image is not paralleled with both sides of the media.
Step
Check printer installation placement.
1
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
Properly load document into the ADF unit assembly and
2
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
Check for obstructions in the area of the media feed
3
path in the ADF.
Is the media feed path free from any obstructions?
Is the ADF left cover assembly properly and evenly
4
closed.
Check the ADF/pick roll assembly for damage and
5
wear.
Is the ADF feed/pick roll assembly free from damage
and wear?
Check the ADF separator roll.
6
Is the ADF separator roll free from damage and wear?
Service Manual
2-180
Check Yes No
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem
resolved.
Go to step 4. Remove
obstructions.
Go to step 5. Open then
properly close
the ADF left
cover assembly.
Go to step 6. Replace the
ADF feed/pick
roll assembly.
Go to
"ADF
feed / pick roll
assembly
removal" on
page 4-56.
Go to step 7. Replace the
ADF separation
roll.
Go to
"ADF
separator roll
removal" on
page 4-57.
Previous
Next
Go Back