Lexmark X651de Service Manual page 105

Error
code or Error contents
message
28x.54 Eject motor encoder
not detected
x = bin
number Applies to:
StapleSmart finisher
28x.55 Eject motor
overspeed failure
x = bin
number Applies to:
StapleSmart finisher
28x.56 Eject motor
underspeed failure
x = bin
number Applies to:
StapleSmart finisher
28x.57 Sensor (stapler pass
through) static jam
x = bin
number Applies to:
StapleSmart finisher
28x.58 Sensor (stapler pass
through) late jam
x = bin
number StapleSmart finisher
28x.59 Staple ready home
position jam
x = bin
number Applies to:
StapleSmart finisher
28x.60 The status of stapler
motor is not defined
x = bin
number Applies to:
StapleSmart finisher
Description/Action
The eject motor encoder
detection is lost during normal
operation.
The eject motor rotate at the
specified speed
The eject motor rotate at the
specified speed
Media remains on the sensor
(stapler pass through) during
the warm up sequence.
The media is late reaching the
sensor (stapler pass through)
within the specified time.
The sensor (self priming) within
the stapler unit assembly does
not detect a ready staple in the
specified time after the staple
job was sent.
A software failure has occurred
with the output option.
Possible repair actions
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
Go to sensor (stapler pass
through) static jam service
check.
See
"Sensor (stapler pass
through) static jam service
check" on page 2-146.
See
"Sensor (output pass
through) late jam service
check" on page 2-146.
1. Check all the connections on
the controller card and the
stapler assembly.
2. Remove the staple cartridge
and remove all jammed
staples. If the cartridge is
jammed and can not be
removed, go to step 3.
3. Remove the stapler
assembly.
Go to
"MFP stapler assembly
stapler unit assembly
removal" on page 4-207.
4. Manually rotate the drive
gears and reset the stapler.
Remove all jammed staples
then reinstall the stapler
assembly.
5. If problem remains, replace
the stapler assembly.
Go to
"MFP stapler assembly
stapler unit assembly
removal" on page 4-207.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Diagnostic information
7462
Previous
Next
Go Back
2-71