7462
7. Determine if the printer passes or fails the skew specifications based on the values listed on the table..
Skew Specification
Letter
A4
Legal
8. If the printer does not meet the skew specifications, adjust the reference edge as specified in
assembly adjustment" on page 4-3
mechanical registration adjustment" on page 4-2
9. Check the registration by looking at the dots at the edges of the page. Adjust as needed.
Service Manual
3-102
(L2-L1)
(R2-R1)
≤1.4 mm
≤1.4 mm
≤1.5 mm
≤1.5 mm
≤1.8 mm
≤1.8 mm
or adjust the printhead as specified in
as needed.
(T2-T1)
(B2-B1)
≤1 mm
≤1 mm
"Alignment
"Polygon printhead
Previous
Next
Go Back