Installing The Virtual Ip Cards To The Pbx; Installing Additional Activation Keys; Configuration Of The Activation Keys - Panasonic KX-NS1000 Installation Manual

5.4.3 Installing the Virtual IP Cards to the PBX

5.4.4 Installing Additional Activation Keys

The corresponding number of IP trunks, IP telephones or enhanced features can be activated by installing the
downloaded activation key file(s) using Web Maintenance Console.
Installing the Activation Key Files
Be sure to connect the PC to the PBX in advance. For details about Web Maintenance Console, refer to
"5.3 Starting Web Maintenance Console".
1.
Log in to Web Maintenance Console using the Installer level account.
2. Click Maintenance ® Utility ® Activation Key Installation.
Activation Key Installation window will be displayed.
3.
Click Browse and specify the directory where the activation key files are stored, and click Open.
4.
A list of activation key files stored in the specified directory is displayed. Check the boxes next to the
activation keys to install to the PBX, and click Install.
5.
The activation keys will be copied to the Master unit, and then the activation keys that Slave units require
will be copied to the Slave units of the One-look network. When installation is complete, the message,
"The activation key has been installed and activated successfully!" is displayed.
6.
Click Apply.
Notice
The activation key file can only be installed in the PBX with the MPR ID number entered when the activation
key file was downloaded. The activation key file cannot be reissued unless the mother board crashes.
Note
•
You can click the provided link to directly access activation key information and programme the number
of activated IP trunks and IP softphones.
•
For information about programming activation keys using Web Maintenance Console, refer to "9.3 PBX
Configuration—Configuration—Slot—Activation Key" in the PC Programming Manual.

5.4.5 Configuration of the Activation Keys

Depending on your configuration, it may be necessary to programme the number of provided IP Trunk channels
to be used for H.323 trunks. By default, all of the provided IP Trunk channels will be used for SIP trunks.
5.4.5 Configuration of the Activation Keys
1. a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
Click Virtual.
2. a.
Click on the name of the desired card.
b.
From the Total number of cards drop-down list,
select the desired number of cards.
3. A confirmation message will be displayed. Click OK.
Installation Manual 149