Panasonic KX-NS1000 Installation Manual page 146

5.4.1 Easy Setup Wizard
d.
Click Next.
When not using a DHCP server:
a.
Select Use the following IP address.
b.
Enter an IP address
be specified depending on your network configuration.)
c.
Select Use the following DNS server address.
d.
Enter the preferred and alternative DNS IP addresses
e.
Select Use the following DSP IP address.
f.
Enter up to 2 IP addresses
g.
Click Next.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
5.
In Registration Setting, the IP Terminal Registration Mode and the One Look Networking (Trial
Activation Key) can be set.
a.
Select the IP Terminal Registration Mode:
•
Manual: Select this mode to manually register IP terminal information.
•
Full Automatic: Select this mode to automatically register IP terminal information.
•
Extension Number Input: Select this mode to automatically register IP terminal information except
its extension number. The extension number can then be registered from the IP telephone
manually.
Note
•
•
b.
For One Look Networking (Trial Activation Key), specify whether to activate the 60-day One-look
Networking Trial Activation Key.
–
If Active is selected, the 60-day trial will begin when the Easy Setup Wizard is completed.
–
If Non Active is selected, you will have to activate the trial manually in order to use One-look
Networking Features on a trial basis.
c.
Click Next.
If Slave has been selected in step 2, the Easy Setup Wizard will finish at this step. If LAN settings have
been changed from their default values in step 4, you will be prompted to restart the PBX. Click OK to
restart the PBX. Otherwise, the login screen will be displayed.
To add the PBX as a Slave unit PBX to the One-look network, use the Add Site Wizard from the Master
unit PBX's Home Screen.
6.
In SNTP / Daylight Saving, enter information for Automatic Time Adjustment and Daylight Saving, and
then click Next.
7.
In Maintenance Setting, the Installer password, information for SNMP Setting and SNMP Manager can
be entered.
a.
Enter a password for the Installer level account in Installer password. Confirm your input in
Re-enter.
b.
Specify settings for SNMP Setting and SNMP Manager if necessary. If you are unsure of your
network's SNMP settings, contact your network's administrator.
c.
Click Finish.
8.
Follow the prompts of the Easy Setup Wizard. After the Easy Setup Wizard is completed, if LAN settings
have been changed from their default values in step 4, you will be prompted to restart the PBX. Click OK
to restart the PBX. Otherwise, the login screen will be displayed.
9.
Log in with the Installer level account using the password entered during Easy Setup Wizard.
The Home Screen is displayed. You may now begin programming the PBX.
146 Installation Manual
, Subnet Mask
*1
for each installed DSP card.
*1
Full Automatic and Extension Number Input registration methods may not be available for
certain types of IP terminals. In such cases, select the Manual registration method.
For more information about the IP terminal registration modes, refer to "5.9.1 Registering
IP Telephones".
, and Default Gateway
*2
.
*1
. (The default gateway may not need to
*1