Panasonic KX-NS1000 Installation Manual page 155

Note
For more details about gateway settings, refer to "9.4 PBX Configuration—Configuration—Slot—System
Property—GW Settings–Main" in the PC Programming Manual.
5.6.2 Programming the Address Translation Table
3. a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
Click System Property.
c.
Click the V-IPGW tab.
d.
Click DN2IP.
e.
When using the PBX code method:
In the Leading Number cell, type the remote PBX
code and starting digit of destination extension.
When using the extension number method:
In the Leading Number cell, type the remote PBX
code and starting digit of destination extension.
f.
In the Remaining Number of Digits cell, type a
number of digits to dial following the leading number.
g.
In GW No./GW Group Selection, select GW No.
h.
In the GW No. cell, select 1 (the gateway entry for
the destination gateway device at the remote PBX).
i.
Click OK.
Installation Manual 155