Panasonic KX-NS1000 Installation Manual page 178

5.8.1 Assigning IP Addressing Information
Notice
•
For "xxx.xxx.xxx.xxx:yyy", enter the IP address and port number of the network router which is
in a same LAN with the PBX.
The router accessed by the SIP phone must have static NAT/NAPT settings enabled so that
the packets sent to xxx.xxx.xxx.xxx:yyy to be transferred to the PBX. For details, refer to
"Connection via Internet" in "5.2 PC Connection" and "Internet Connection (SSL
Connection):" in "5.3 Starting Web Maintenance Console".
•
Configuration files must end with an empty line.
b.
Save the text file as "UT_ACS.cfg".
2.
Confirm the IP address of the SIP phone.
a.
Press Setting or Setup (soft button) on the SIP phone.
b.
Select "Information Display", then press [ENTER].
c.
Select "IP address".
The IP address of the SIP phone will be displayed.
d.
Press [CANCEL].
3.
Open the port of the SIP phone, which is used by the PCs to access Web user interface.
a.
Press Setting or Setup (soft button) on the SIP phone.
b.
Press [#][5][3][4].
c.
Select "On" for "Embedded web", then press [ENTER].
Note
If no operation are made for 30 minutes, the port will be closed again automatically.
4.
Access the Web user interface from the PC.
a.
Open your Web browser, and then enter "http://"followed by the SIP phone's IP address into the
address field of your browser.
b.
For authentication, enter your ID and password, and then click OK.
The Installer Level ID and Password are as follows.
ID: instoperatoruserid
Password: instpass
c. Select Maintenance ® Import Configuration File.
d.
Click Browse... , and then select the configuration file (UT_ACS.cfg).
e.
Click Import.
When the configuration file is successfully imported, the SIP phone starts to access the PBX
automatically.
178 Installation Manual