Panasonic KX-NS1000 Installation Manual page 135

Note
When connecting the UPS, use only the USB cable included with the UPS and do not use USB hubs
to connect the UPS and the PBX.
To UPS
2.
Follow the instructions in the documentation of the UPS to setup and start the UPS.
System Initialisation Procedure
Notice
When a UPS is connected, make sure it is started as instructed in the documentation for the UPS.
1.
Slide the System Mode Switch to the "SYSTEM INITIALIZE" position.
STATUS Indicator
2.
Turn on the power switch of the PBX. The STATUS indicator will flash green.
3.
While the STATUS indicator is flashing green, slide the System Mode Switch back to the "NORMAL"
position. Depending on the configuration, initialisation takes about 2.5 minutes. If successfully executed,
the STATUS indicator will stop flashing and remain lit up.
Note
When DSP card(s) are installed and a DHCP server is not connected, each installed DSP card cannot
acquire an IP address, and the STATUS indicator will turn red.
System Mode Switch
4.12 Starting the PBX
Installation Manual 135