Panasonic KX-NS1000 Installation Manual page 193

2.
Enter an extension number.
Note
When no extension number is entered in this step, the process will time out and the IP-PT will be
registered without an extension number.
3.
Press [ENTER] on the IP-PT.
4.
Press [PAUSE] or "EXIT" on the IP-PT.
For KX-UT Series SIP Phones
If networking settings have been completed, when KX-UT series SIP phones are connected to the same
network as the PBX, they will be registered automatically as same as when they are registered in Full Automatic
mode. No registration procedure is required.
Note
No more than 64 IP-PTs can register extension numbers at the same time.
Manual Mode
For IP-PTs or KX-UT Series SIP Phones
After connecting IP-PTs or KX-UT series SIP phones to the PBX over a network, register those IP terminals
to the PBX manually.
Follow the procedure below for registration.
To register the IP-PT or KX-UT series SIP phone by entering the MAC address directly:
1. a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
For IP-PTs:
Click Virtual ® V-IPEXT32.
For KX-UT series SIP phones:
Click Virtual ® V-UTEXT32.
c.
For IP-PTs:
Move the mouse pointer over the V-IPEXT32 card
(Virtual 32-Channel VoIP Extension Card).
For KX-UT series SIP phones:
Move the mouse pointer over the V-UTEXT32 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
5.9.1 Registering IP Telephones
Installation Manual 193