4.2
The Battery Pack
Removing the Battery Pack
To remove the T1900/T1900C battery pack, follow the steps below and refer to Figure 4-1.
1.
Turn off the power to the T1900/T1900C, and, if attached, disconnect the AC
adapter, power cord and all external cables connected to the computer.
2.
Slide open the cover to the battery latch (located on the left, front of the computer)
and press the release button until it clicks. The battery will pop out slightly
(Figure 4-1).
3.
Firmly grasp the battery pack and pull it out.
Installing the Battery Pack
NOTE: The battery pack is designed to fit into the T1900/T1900C in only one way.
To install the battery pack, follow the steps below and refer to Figure 4-1.
1.
Gently slide the battery pack into the battery slot making sure the groove on the
side of the battery faces left and the smooth side faces right.
2.
Push the battery pack in until it locks into place.
4-4
Figure 4-1 Removing the Battery Pack