Removing The Display Assembly - Toshiba T1950 User Manual

4.9 Display Assembly

Removing the Display Assembly

To remove the T1900/T1900C's display assembly, follow the steps below and refer to Figures
4-15 through 4-17.
1. Turn off the power to the T1900/T1900C, and, if attached, disconnect the AC
adapter, power cord and all external cables connected to the computer.
2. Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, keyboard, keyboard base plate, and display mask as described in Sections
4.2 through 4.8.
3. Set the display unit at a 90° angle to the base and remove the two hinge covers
from the left and right hinges (Figure 4-15).
4. Remove the four M2.5x8 silver screws and two M2.5x10 screws on the system
board cover (Figure 4-16). Note that the M2.5x8 screw under the hinge secures the
ground wire.
5. Peel back the clear plastic insulator covering the display cable and lift out the
system board cover. As you lift the cover, place your fingers under the right side
to keep the memory card housing intact.
4-20
Figure 4-15 Removing the Hinge Covers