6.
Remove the three M2x3 black screws securing the FDD bracket and remove the
bracket (Figure 4-25).
Installing the Floppy Disk Drive and Mouse/KB Board
To install the T1900/T1900C's floppy disk drive and mouse/KB board, follow the steps
below and refer to Figures 4-23 through 4-25.
1.
Place the FDD bracket on the FDD and secure it with the three M2x3 black
screws (Figure 4-25).
2.
Secure the mouse/KB board with two M2.5x4 screws to the FDD bracket (Figure
4-24).
3.
Place the FDD assembly in the computer, right side first, and secure the mouse/KB
board with two M2.5x6 screws (Figure 4-23).
4.
Install the lower system board, upper system board, display assembly, display
mask, HDD, status indicator panel, keyboard, top cover, optional PCMCIA card,
optional memory card and battery pack as described in Sections 4.11 through 4.2.
4-30
Figure 4-25 Removing the FDD Bracket