Toshiba T1950 User Manual page 49

6. Select the desired subtest from the subtest menu and press Enter. The following
messages appear:
TEST LOOP
ERROR STOP
Use the arrow keys to move the cursor to the desired option and press Enter.
Selecting YES for TEST LOOP sets the test to run continuously until it is halted by
the user. Selecting NO returns the screen to the main menu after the test is com-
plete.
Selecting YES for ERROR STOP stops the test program when an error is found and
displays the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
These three selections have the following functions:
1: Terminates the test program and exits to the subtest menu.
2: Continues the test.
3: Restarts the test from the error.
Use the arrow keys to move the cursor to the desired option and press Enter.
Selecting NO for ERROR STOP keeps the test running even if an error is found.
Table 3-1 in Section 3.3 describes the function of each test on the subtest menu. Table 3-3 in
Section 3.14 describes the error codes and error status for each error.
: YES
: YES
1: Test end
2: Continue
3: Retry
3-5