Toshiba T1950 User Manual page 38

Procedure 2 Message Check
When the T1900/T1900C's HDD does not function properly, some of the following error
messages may appear on the display. Start with Check 1 below and perform the other checks
as instructed.
Check 1 If any of the following messages appear, perform Check 2. If the following mes-
sages do not appear, perform Check 4.
Note that the error messages appear on the display for five (5) seconds, then
disappear.
HDC ERROR
HDD #0 ERROR
HDD #1 ERROR
Check 2 If either of the following messages appears, perform Procedure 3. If the following
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key
Check 3 Using the Toshiba MS-DOS system disk, install a system program on the hard disk
using the SYS command.
If the following message appears on the display, the system program has been
transferred to the HDD. Restart the T1900/T1900C. If the error message still
appears, perform Check 4.
System transferred
Check 4 The HDD is connected to the lower system board through an HDD flexible cable.
This cable can become disconnected or damaged. Disassemble the T1900/
T1900C as described in Chapter 4, Replacement Procedures. If the HDD is not
connected, reconnect it to the system board and return to Procedure 1. If the HDD
is firmly connected to the system board, perform Procedure 3.
Lower System Board
2-20
or
or
or
PJ203
HDD