Lexmark CX310n Service Manual page 68

Message
Configuration change, some held jobs were
not restored [57]
Defective flash detected [51]
Error reading USB drive. Remove USB.
Error reading USB hub. Remove hub.
Incompatible tray [x] [59]
Incorrect paper size, open [paper source]
[34]
Insert Tray [x]
Insufficient memory for Flash Memory
Defragment operation [37]
Action
Held jobs are invalidated because of any of the following
possible changes in the printer:
•
The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer
attached to the USB port.
•
The printer hard disk contains print jobs that were stored
when the hard disk was installed in a different printer
model.
From the printer control panel, select Continue to clear the
message. For non‑touch‑screen models, press OK to confirm.
Try one or more of the following:
• Replace the defective flash memory card.
• From the printer control panel, select Continue to ignore
the message and continue printing. For non‑touch‑screen
models, press OK to confirm.
•
Cancel the current print job.
An unsupported USB device is inserted. Remove the USB
device, and then insert a supported one.
An unsupported USB hub has been inserted. Remove the USB
hub, and then install a supported one.
Remove, and then reinstall the indicated tray to clear the
message.
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, select Continue to clear
the message and print using a different tray. For
non‑touch‑screen models, press OK to confirm.
• Check the tray length and width guides and make sure the
paper is loaded properly in the tray.
• Make sure the correct paper size and type are specified in
the Printing Preferences or in the Print dialog.
• Make sure the paper size and type are specified in the
Paper menu on the printer control panel.
• Make sure that the paper size is correctly set. For example,
if MP Feeder Size is set to Universal, then make sure the
paper is large enough for the data being printed.
•
Cancel the print job.
Insert the indicated tray into the printer.
Try one or more of the following:
•
From the printer control panel, select Continue to stop the
defragmentation and continue printing. For
non‑touch‑screen models, press OK to confirm.
Diagnostic information
68
7527