Error code
954.xx
Service NVRAM Failure
955.xx
Service Code CRC <loc>
956.xx
Service Controller Board
957.xx
Service Controller Board
958.xx
Service NAND Failure
959.xx
Service Invalid Firmware
959.0x
Service System Board
960.xx
Service Memory Error
961.xx
Service Memory Failure
962.xx
Service Memory Failure
Description
The NVRAM chip failure with controller part.
The Code ROM or NAND flash failed the Cyclic
Redundancy Check (CRC) check or the NAND
experienced an uncorrectable multi-bit failure.
<loc> indicates the source of the failure and has
one of the following values:
•
CRC Failure: The source is a failing package
indicated by Pn where n is the package
number. This error could occur on a
controller with ROM or NAND flash and
could occur as a result of the CRC check
done when the machine is powered on. The
range of package numbers is from 0 to 15.
•
Error Correction Code (ECC) Failure: The
source is a failing page indicated by Bn
where "n" is the page number. This error
occurs only if a multi-bit failure is detected
during the ECC execution. Single bit failures
will be corrected automatically and will not
result in a service error. The range of page
numbers is from 0 to 1023.
Controller board failure. Processor failure.
Check on .02 for fan error.
Controller board failure. ASIC failure.
Printer has performed more than 100 "shift and
reflash" operations as a result of ECC bit
corrections.
Controller verification failure of system boot
code.
System hardware failure.
RAM memory error: RAM soldered on the
board is bad.
RAM memory error: slot 1 RAM is bad.
RAM memory error: slot 2 RAM is bad.
Diagnostic information
Action
•
POR the printer.
•
If the problem persists, then replace the
controller board. See
removal" on page
•
Update the firmware.
•
POR the printer.
•
If the problem persists, then replace the
controller board. See
removal" on page
•
POR the printer.
•
If the problem persists, then replace the
controller board. See
removal" on page
•
Check RAM in slot 2.
•
If RAM is ok, then POR the printer.
•
If the problem persists, then replace the
controller board. See
removal" on page
101
7527
"Controller board
239.
"Controller board
239.
"Controller board
239.
"Controller board
239.