Disable Scanner; Auto Color Adjustment - Lexmark CX310n Service Manual

13
Use the plus or minus to increase or decrease the settings value for horizontal adjust and top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
14
Select Submit to accept the value.
15
Verify the changes by placing the print quick test page face down and selecting Copy Quick Test.
16
Repeat steps 13, 14, and 15 as needed.
To manually register the flatbed, perform the following steps:
1
In the Configuration Menu, select the Scanner Manual Registration menu item.
2
Select the Print Quick Test Page menu item.
3
To view and adjust the flatbed registration, place the quick test page into the flatbed.
4
Select the Copy Quick Test Page item.
5
After the quick test page copies, select Flatbed.
6
Use the plus or minus to increase or decrease the settings value for the left or top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
7
Select Submit to accept the value.
8
Place the print quick test page on the flatbed and select Copy Quick Test.
9
Repeat steps 5 and 6 as needed.
10
To exit REGISTRATION select Back or Stop.

Disable scanner

This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on for the
new settings to take effect.
To change this setting:
1
Select Disable Scanner from the Configuration menu.
2
Scroll through the setting's other possible values. The settings are Enable, Disable, ADF disable.
3
To save the setting's new value, select Submit.
4
Select Submit to accept the value.

Auto Color Adjustment

Auto Color Adjustment sets the suggested number of pages which the printer should print between consecutive
calibrations.
Selections are Off and the values between 100 and 1000 in increments of 50. The default is 500 pages.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received while
printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job to perform
a calibration. If a user is using the menus, including the Configuration Menu and the Diagnostics Menu, an automatic
color adjust calibration does not occur.
Service menus
196
7527