Adjusting Margins - Lexmark CX310n Service Manual

Adjusting margins

Description Value
Top margin -50 to +50
Each increment corresponds to 8 scans at a 600
dpi scan rate (0.0133 inches or 0.339 mm).
The default is 0.
Bottom margin -25 to +25
Each increment causes approximately 0.55 mm
shift in the bottom margin.
The default is 0.
Left margin -25 to +25
Each increment corresponds to 4 pixels at 600 dpi
(0.00666 in. or 0.1693 mm).
The default is 0.
Right margin -50 to +50
Each increment corresponds to an approximate
shift of 4 pixels at 600 dpi.
The default is 0.
Skew -100 to +100
Each increment corresponds to 1/1200 of an
inch.
The default is 0.
6
Print another copy of the Quick Test to verify your changes.
7
Continue changing the settings by repeating steps 3 through 5.
To exit Registration, press Back or Stop.
Direction of change
A positive change moves the image down the
page and increases the top margin. A negative
change moves the image up and decreases the
top margin. No compression or expansion occurs.
A positive offset moves text down the page and
narrows the bottom margin, while a negative
offset moves text up the page and narrows the
bottom margin. The image is compressed or
expanded.
A positive change moves the image to the left,
and a negative change moves the image to the
right. No compression or expansion occurs.
A positive change moves the image to the left,
and a negative change moves the image to the
right.
A positive value causes the left end of the scan
line to move down the page. A negative value
causes the left end of the scan line to move up
the page. The right end stays fixed. There is no
compression or expansion of the image.
Service menus
165
7527