4
Remove the sensor retaining plate (C).
5
Gently remove the sensor from the bracket by pressing in on the latches (D).
Installation notes:
•
Clean the contact surface where you removed the sensor retaining plate, or where you need to install the new one.
•
Guide the latches that hold the sensor in the bracket into place.
•
Squeeze the latches together until they latch to the metal frame.
•
Remove the backing from the new plate, and place the plate on the surface between the sensor mounting legs.
•
Reconnect the cable, and reroute the cable through the retainer.
Narrow media sensor flag removal
1
Open the front cover.
2
Press upward on the tab (A) to unsnap the narrow media sensor flag, and remove the flag.
Note: Be careful to not dislodge the sensor. Because of space, this flag should be installed on the fuser while the
fuser is out.
Repair information
281
7527