Checking Threaded Connections - MTU 12 V 2000 P12 Operating Instructions Manual

Checking threaded connections

1. Check all connected cables to verify that
the two securing elements (1) are engaged
on the lugs (2) so that the respective male
connector (3) is held firmly in place in the
socket.
2. If this is not the case, press the securing el‐
ements (1) concerned in the direction of the
arrow until they engage noticeably.
Checking unassigned connector
sockets
1. Ensure that non-assigned connector sock‐
ets are protected with covering caps.
2. Make certain that the two securing ele‐
ments (1) are engaged in the lugs (2) so
that the covering cap (3) is held firmly in
place in the socket.
3. If this is not the case, press the securing el‐
ements (1) concerned in the direction of the
arrow until they engage noticeably.
Checking pushbuttons and display
1. Pushbuttons: Ensure that
• Pushbutton caps are not damaged
(cracks or similar damage)
• Pushbuttons move easily
• Pushbutton housings are seated secure‐
ly
• Seals (2) between PAN control panels
and LOP housing are not damaged.
2. Display: Ensure that
• Front glass is not damaged or pressed in
• Seal (1) between display housing and
LOP housing is not damaged.
3. Have damaged components replaced im‐
mediately by Service.
152 | Task Description | MS150025/02E 2012-10