Cylinder Head Cover - Removal And Installation - MTU 12 V 2000 P12 Operating Instructions Manual

7.4.2 Cylinder head cover – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Torque wrench, 8-40 Nm
Ratchet
Gasket
Preparatory steps
1. On cylinder head covers with crankcase breather: Loosen clamps.
2. Slide rubber sleeves onto the pipe.
Cylinder head cover – Removal
and installation
1. Remove cylinder head cover with gasket
from cylinder head.
2. Clean installation surface.
3. Check condition of gasket in cylinder head
cover.
4. Replace damaged gasket(s).
5. Install cylinder head cover with screws.
Final steps
1. Slide rubber sleeves onto the relevant pipe connection.
2. Tighten all clamps.
Part No.
F30043446
F30027340
(→ Spare Parts Catalog)
MS150025/02E 2012-10 | Task Description | 97
Qty.
1
1