MTU 12 V 2000 P12 Operating Instructions Manual page 94

Checking diaphragm
1. Remove cover (4).
2. Remove spring (5), gasket (2) and dia‐
phragm (3).
3. Check diaphragm (3) for damage, fit new
diaphragm if used one is damaged.
4. Install diaphragm (3) on housing (1).
5. Install new seal (2) and spring (5) together
with cover (4).
6. Use torque wrench to tighten the screws of cover (4) to the specified torque.
Name
Screw
7. Check diaphragms in further oil separators in the same way.
94 | Task Description | MS150025/02E 2012-10
Size Type
Tightening torque
Lubricant Value/Standard
(Engine oil) 10 Nm −2 Nm