Mitsubishi Electric FR-V500 Instruction Manual page 108

Pr. 52
Signal
Display
Type Unit
PU main
DU LED
monitor
Torque
monitor
(driving/
×
——
regenerative
polarity
switchover)
*1
Trace
—— 38
status
CAUTION
*1 When DA1 (Pr. 54) is selected, high responce output is available.
When DA2 (Pr. 158) is selected, average value is output.
*2 Select this monitor in "Others" of the FR-PU04V (option).
When "100" is set in Pr. 52, the monitored values during stop and during operation differ as indicated below. (The
LED on the left of r/min flickers during stop, and is lit during operation.)
When Pr. 52 = "100", the set speed displayed at a stop indicates speed to be output when the start command is on.
Different from the speed setting based on displayed when Pr. 52 = "5", the value maximum/minimum speed and
speed jump is displayed.
During operation/
during stop
Speed
Output current
Output voltage
Alarm display
REMARKS
• During a reset, the values are the same as at a stop.
During offline auto tuning, the tuning status monitor has priority.
• By setting "0" in Pr. 52, the monitoring of output speed to alarm display can be selected in sequence by the SHIFT key.
• *Speed setting to output terminal status on the PU main monitor are selected by "other monitor selection" of the parameter
unit (FR-PU04V).
• When Pr. 52 = any of "17, 18 and 24", the output current monitor changes to the set monitored data.
When Pr. 52 = any of "19, 20, 23 and 32 to 35, 38", the output voltage monitor changes to the set monitored data.
CAUTION
1. The cumulative energization time and actual operation time are accumulated from 0 to 65535 hours,
then cleared, and accumulated again from 0.
When the control panel (FR-DU04
Use the parameter unit (FR-PU04V) to confirm more than 9999h.
2. The cumulative energization time and actual operation time is not accumulated unless the inverter is
run continuously for more than one hour.
3. When the control panel (FR-DU04
Parameter Settings
Pr. 53 Pr. 54 Pr. 158
DA1 DA2
PU level terminal terminal
meter 12 bits 12 bits
(±10V) (+10V)
× ×
36
× ×
38
Pr. 52
0
During stop
Speed Set speed
Output current
Output voltage
Alarm display
) is used, more than 9999h is displayed as "– – – –".
-1
) is used, the display unit is r/min, V or A only.
-1
Display functions 1 (Pr. 52 to Pr. 56)
Full-Scale Value
of the Level
± Output
Meter Connected
to DA1 and DA2
Pr. 866
×
——
100
During operation
Speed
99
Description
The output torque is monitored.
When the DA1 output monitor is
used, a positive voltage is output
during forward and reverse driving
and a negative voltage is output
during forward and reverse
regeneration.
The trace status is displayed.
0: Stop
1: During pre-trigger
2: Waiting for trigger
3: During trace
4: Trace completion
101: During data output
102: Data output completion
3