Additional Functions (Pr. 59); Remote Setting Function Selection (Pr. 59 ) - Mitsubishi Electric FR-V500 Instruction Manual

3.9 Additional functions (Pr. 59)

3.9.1 Remote setting function selection (Pr. 59
Even if the control panel is located away from the enclosure, you can use contact signals to perform
continuous variable-speed operation, without using analog signals.
Parameter Name
Remote setting
59
function selection
(1) Pr. 59 = "1" or "2"
Acceleration (RH)
Deceleration (RM)
Clear (RL)
Forward rotation (STF)
Power
*External operation speed or PU operation speed other than multi-speed
(2) Pr. 59 = "3"
Acceleration (RH)
Deceleration (RM)
Forward rotation (STF)
Power
*External operation speed or PU operation speed other than multi-speed
REMARKS
• By merely setting this parameter, you can use the acceleration, deceleration and setting clear functions of the motorized
speed setter (FR-FK).
• When the remote function is used, the output speed of the inverter can be compensated for as follows:
For external operation, speed set by RH/RM operation plus external analog speed command
For PU operation mode, speed set by RH/RM operation plus DU/PU digital setting speed
• When any value other than 0 is set in Pr. 59, multi-speed operation is invalid. (Refer to page 77.)
• Speed compensation by terminal 1 is made invalid when speed command by terminal 2 is selected.
Set "1" in Pr. 28 "multi-speed input compensation" to enable speed compensation of terminal 1 (Pr. 28 = "0").
Factory Setting
Setting Range
0 Remote function not activated.
1
Remote function activated: Stored into E
0
2
Remote function activated: Not stored into E
Remote function activated: Not stored into E
3
(Turn on STF (STR) to clear remote setting)
*
ON
ON
ON
ON
*
ON
ON
ON
ON
103
Additional functions (Pr. 59)
speed torque )
Remarks
Pr. 59 = "2"
Pr. 59 = "1"
ON
ON
ON ON
ON
ON
2
PROM.
Extended
2
PROM.
mode
2
PROM.
ON
ON
3