Machining the machining step program manually
6.3 Simulate machining
Contour simulation
Execution of the part program is simulated with this function on the HMI.
Figure 6-16
The selected part program is started for the contour simulation.
Simulation of individual cycles
Note
If the simulation is used to test a single cycle, the display area is divided into the traversing
movements and technology data columns. The technology data cannot be changed in
simulation mode.
Figure 6-17
118
Contour simulation
Simulation of a single cycle - standard simulation
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning