Manual Radius Turning - Siemens SINUMERIK 802D sl Programming And Operating Manual

3. The input field for the taper angle "α" is immediately displayed on a dark background
4. The entered value is immediately accepted using the <INPUT> key.
The taper angle remains active until you exit the "Taper turning" by pressing the "Machining
mode" softkey.
5.3.3

Manual radius turning

Functionality
The "Manual radius turning" function is designed to simplify the machining of inside and
outside radii.
The positions of the axes at the time that machining is selected form the starting point for the
radii to be traversed.
When you move the axis direction switch, the control then uses the input values to
interpolate (and simultaneously traverse) the X and Z axes accordingly.
The programmed axis feed then applies to the path being traversed and not to the
corresponding axis.
NOTICE
The desired radius is traversed only by means of an axis direction switch or axis direction
keys of the machine control panel depending on the machine equipment.
A traversal using the handwheels is not possible!
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
when the machining mode is selected. You must enter the angle using the <Numeric
keys>.
A positive angle value rotates the coordinate system in traverse direction X+.
A negative angle value rotates the coordinate system in traverse direction X-.
5.3 Manual machining with machining types
Manual machining
49