Siemens SINUMERIK 802D sl Programming And Operating Manual page 56

Manual machining
5.4 Manual machining using cycles (functions)
3. The function was parameterized (e.g. thread tapping).
4. Start machining using the <NC-Start> key.
56
This softkey takes you back to the main screen.
If you have edited any values, the following prompt window appears:
Figure 5-19 Cycles prompt text
Your inputs are accepted when you press the "OK" softkey.
Your inputs are discarded when you press the "Abort" softkey.
Activate the function using the "OK" softkey.
The following execute screen appears:
Figure 5-20 Example of executing a machining operation
The current machining status is displayed in the center of the execute screen. This status
could be one of the following:
– Machining not started
– Machining active
– Machining aborted
– Machining interrupted
– Machining finished
In the example, the text "Machining not started" is displayed.
The machining operation on the workpiece is executed.
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning