Siemens SINUMERIK 802D sl Programming And Operating Manual page 21

3. Then use the handwheel to move the axes to a position from which they can approach
4. Select the <JOG REF> operating mode.
5. Using the axis direction key, start the X axis in the positive direction (X+).
6. Repeat step 5 for the Z axis.
7. Select the <JOG> operating mode.
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
the reference point in a positive direction.
CAUTION
In this operating state, the axes can be moved only by means of the handwheel.
Traversing the axes using the axis traversing switch is inhibited. The spindle cannot be
started in this operating state.
The reference point for the X axis is then approached automatically.
The axis stops automatically when it has completed this process.
The symbol appears in front of the axis name in the display.
NOTICE
The axes must be referenced in this sequence, i.e., the X axis first, followed by the Z
axis. No other sequence will be accepted by the controller.
You have now referenced both axes.
Figure 3-6 Reference points reached
You are in the "Manual Machine Plus" operating area.
Turning On, Reference Point Approach
3.2 Reference point approach
21