Extended Grooving - Siemens SINUMERIK 802D sl Programming And Operating Manual

Multiple tapping
Notice: When multiple parting is selected, make sure that there is sufficient clearance from
the spindle as measured from starting position "Reference z0" to allow all parameterized
parting operations to be performed. There is otherwise a risk of collision between the tool
and the chuck!
-> Check the plausibility of the input values before pressing NC start!
The machining sequence is as follows:
1. Machining takes place in the same way as for machining of "multiple grooves". The only
2. Finally, the original position of the axes before the start of machining is approached
5.4.5.5

Extended grooving

Operating sequences
You can access the grooving cycle overview by pressing the softkey "Grooving" in the basic
screen for "Manual Machine Plus".
Figure 5-30
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
DANGER
difference lies in the fact that this is a "parting" rather than a "grooving" operation.
diagonally.
Grooving cycle overview - "Extended groove" selected
5.4 Manual machining using cycles (functions)
Manual machining
71