General Parameters - Siemens SINUMERIK 802D sl Programming And Operating Manual

Manual machining
5.4 Manual machining using cycles (functions)
5.4.2

General parameters

General parameters
When parameterizing the particular functions, among others, the following general
parameters are available:
Parameter
Function name
Tool T
Compensation D
Direction of spindle rotation
Feed value F
Type of feedrate
Spindle speed S
Spindle type
Spindle speed MR
limitation
Coolant
Machining
Position
Reference z0
Note
Additional parameter descriptions for the individual functions are provided in the
corresponding chapters.
58
Description
Number of the selected function
Tool number
Tool offset number
Toggle field for spindle direction of rotation (clockwise/counterclockwise)
Feed value
Toggle field for feed type (mm/min or mm/rev)
Spindle speed value
Toggle field for spindle type (rev/min or m/min)
Speed limitation for constant cutting rate
Toogle field for coolant function
(coolant OFF/coolant ON)
The type of machining operation can be selected in this toggle field. The following options
are available: "Complete machining" -> "Roughing only" -> "Finishing only"
The machining direction can be selected with the first toggle field.
The following options are available: "Outside right" -> "Inside right" -> "Outside left". The
diagram displayed on the screen changes to indicate which option is selected.
The cutting direction can be selected with the second toggle field.
Available selection: infeed in the longitudinal axis and roughing cut in the transverse axis
(face), or roughing cut in the longitudinal axis and infeed in the transverse axis (long.). The
current selection is shown in the form of a diagram on the screen.
Contour start position in the longitudinal axis (absolute position of the Z axis).
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning