Siemens SINUMERIK 802D sl Programming And Operating Manual page 112

Machining the machining step program manually
6.1 Tool change in the machining step program
3. To select the tool, enter the tool number and the cutting edge number in the input fields
4. If the tick is set in the field "G75" (approach fixed point), the controller travels to a stored
5. Press "OK".
6. The following options are available:
112
"T" and "D", respectively.
- OR -
Use the <Tab key> to change to the list and position the cursor on the appropriate tool
and press the <INPUT> key to confirm the selection.
The selected tool is copied into the "T" input field.
fixed point before the tool change.
Figure 6-7 Tool change in the machining step program, first prompt
With this prompt, you decide whether the tool should be used in all subsequent steps up
to the next tool change.
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning