Turning On, Reference Point Approach; Entry To The "Manual Machine Plus" Operating Area - Siemens SINUMERIK 802D sl Programming And Operating Manual

Turning On, Reference Point Approach

3.1

Entry to the "Manual Machine Plus" operating area

Operating sequences
Note
The operating area "Manual Machine Plus" runs only in Siemens mode, and not in ISO
mode.
Proceed as follows to open the "Manual Machine Plus" application:
Note
If the controller has already been preconfigured to "Manual Machine Plus" by the machine
manufacturer, items 1 to 3 can be ignored in the following description. The operating area
"Manual Machine Plus" is activated once the controller has been started up.
If you have not yet executed a reference point approach, you will be in the operating mode
Reference point approach (see Fig. Reference point approach) after start-up.
1. The NC boots into the JOG REF operating mode of the NC basic machine.
2. Select the JOG operating mode.
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
The interface can be seen in the screenshot below:
Figure 3-1 "Position" operating area
3
17