Panasonic KX-TD1232 Program Manual page 14

General Programming Instructions
Viewing the Display
The display gives you helpful information, such as what you should do now, what you have
done, etc.
The KX-T7433, KX-T7436, KX-T7230 and the KX-T7235 utilize two information lines for
programming. The upper line is called the Message Line and the lower one is called the
Function Line.
The Message Line (upper) shows you what you should do or what you should select. It also
allows you to confirm what you have just entered. The display capacity is 16 digits. If your
entry exceeds the capacity, you can shift the display by pressing
The Function Line (lower) shows the current function of the soft buttons. These functions
change with the programming procedures.
SYS-PGM NO? →
CLR
KX-T7230 Display
SYS-PGM NO? →
CLR
KX-T7433 Display
Before entering the programming mode
Before entering programming mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone.
Entering the programming mode
Press PROGRAM (or PAUSE) + + # and enter your System
Password (default=1234).
• The display shows the Initial Message: SYS-PGM NO?
Note
• If your telephone set does not have a PROGRAM button, substitute it with the PAUSE
button.
• If nothing is entered in five seconds after the PROGRAM (or PAUSE ) button is pressed,
it is canceled.
• The System Password entered is not shown on the display. The System Password can be
changed by System Programming. Refer to Section [107] System Password.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
14
← Message Line
← Function Line
NEXT
← Message Line
← Function Line
NEXT
or
SYS-PGM NO? →
CLR NEXT
KX-T7436 / KX-T7235 Display
button.
← Message Line
← Function Line
Programming Guide