Did / Tie Wink Time Out Assignment - Panasonic KX-TD1232 Program Manual
Digital super hybrid system
Hide thumbs
Also See for KX-TD1232:
- User manual (226 pages) ,
- Installation manual (160 pages) ,
- Programming manual (443 pages)
Table of Contents
Advertisement
General Programming
[435] DID / TIE Wink Time Out Assignment
Description
The DID / TIE outgoing method can be set to the wink mode in program [432] DID / TIE
Outgoing Assignment. This program sets the time the system waits for the confirmation wink
signal after an outside line is seized according to your central office service.
Selection
• DID / TIE format number:
1 to 8,
• Time:
1 through 127 ( 64 milliseconds is the actual time)
Default
All DID / TIE formats — 16
Programming
1.
Enter 435.
Display: 435 WINK TIMEOUT
2.
Press NEXT.
Display: Format NO?
3.
Enter a DID / TIE format number.
To enter DID / TIE format number 1, you can also press NEXT.
Display example: 1:16
4.
Enter the time.
To change the current entry, press CLEAR and enter the new number.
5.
Press STORE.
6.
To program another DID / TIE format, press NEXT or PREV, or SELECT and the desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• You cannot leave the entry empty.
• To assign all DID / TIE formats to one selection, press the
display shows the contents programmed for DID / TIE format number 1.
228
( =all DID / TIE formats)
key in step 3. In this case, the
Programming Guide
Advertisement
Table of Contents
