Table of Contents
Advertisement
Playing back tape repeatedly
C
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold PLAY ( 3 )
for more than 5 seconds.
The play indicator ( # ) on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback, press STOP ( 7 ) on the Remote or
STOP/EJECT ( 7
0 ) on the front panel.
/
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is
possible only if the cassette was recorded in STD mode.
Adjusting tracking condition
D
— Tracking Adjustments
Automatic tracking adjustment
This VCR automatically adjusts the tracking condition.
Whenever you insert a tape and start playback,
automatic tracking starts working and continuously
analyzes the signal to enable optimum picture quality
during playback.
Manual tracking adjustment
If automatic tracking cannot eliminate noises well during
playback, use the manual tracking following the
procedures below.
You can also use the manual tracking during slow
motion playback (
pg. 33).
1
Activate manual tracking
Press CH + and – on the front panel at the same
time during playback.
2
Eliminate the noises on the TV screen.
Press CH + or –.
Press it briefly for a fine adjustment, or press and
hold for a coarse adjustment. Watch the screen
and continue adjustment until optimum picture
and sound quality are achieved.
To reactivate automatic tracking, press CH + and
– on the front panel at the same time. The
automatic tracking becomes active again.
Selecting monitor sound
E
— Audio Monitor
You can select the desired monitor sound.
While playing back a tape on which stereo sound or SAP
sound is recorded, press A. MONITOR on the Remote.
Each time you press the button, sound changes as follows:
S-VHS/VHS
HI-FI
NORM HI-FI
HI-FI: Normally select this.
Hi-Fi sound is played back.
HI-FI L: Sound on the left Hi-Fi channel is played back.
HI-FI R: Sound on the right Hi-Fi channel is played back.
NORM:Sound on the normal track is played back.
NORM HI-FI:
Both sounds on the Hi-Fi track and normal
track are mixed and played back.
D-VHS
HI-FI
HI-FI: Normally select this.
HI-FI L: Sound on the left Hi-Fi channel is played back.
HI-FI R: Sound on the right Hi-Fi channel is played back.
NOTES:
The above indication appears when "SUPERIMPOSE" is set to
"ON" (
pg. 56), though the monitor sound changes in
sequence.
If the tape being played back has no Hi-Fi sound track, the
normal sound track will be heard regardless of this setting.
EN
HI-FI L
HI-FI R
NORM
HI-FI L
HI-FI R
23
Advertisement
Table of Contents
