Notice For Connection To The Telecommunication System - Sagem PHONEFAX 320 User Manual

PROBLEM
REMOVE DOCUMENT
MEMORY FULL
• Other
5. NOTICE FOR CONNECTION TO THE TELECOMMUNICATION
SYSTEM
1. BABT Certificate Number/Approval Number for the
SAGEM PHONEFAX 320 N° 609099
SAGEM PHONEFAX 325 N° 609605
Approved for connection to telecommunication system specified in the instructions for use subject to the
conditions set out in them.
2. This apparatus has been approved for the use of the following facilities:
‡
Facsimile
‡
Simple telephone
‡
Terminal and subsriber identifier
‡
Transmission status report (send report only)
‡
Manual mode (RX and TX)
‡
Auto-Answering
‡
Auto calling
‡
Delayed transmission- Time recorder and logs
‡
Automatic redial (5 times, 5 minutes intervals)
‡
Fax switch
‡
Polling RX (To poll a document from on a distant fax)
‡
Polling TX (prepare a document to be poll)
‡
Automatic document feeder
‡
Halftone 16 shades of grey
‡
Modem Fax up to 14400 bps
‡
Facsimile transmission and reception
‡
Call progressing mode
‡
Full Numeric Handsfree
‡
Answering Recording Device
‡
Fax Answering Device
Any other usage will invalidate the approval of the apparatus if as a result, it then ceases to conform to the
standards against which approval was granted.
3. The connection to the telecommunication system must be unplugged before the earth is disconnected. The
connection to the telecommunication system must be hardwired.
4. This apparatus may be used on the telecommunication employing loop disconnect or MF dialling.
5. This apparatus is suitable for connection to direct exchange lines on the PSTN directly or via a compatible
PABX (selection done by parameter setting).
24
• Open the front cover and check the document circuit.
• Print out faxes received and/or listen to the voice messages on the
TAD.
• Disconnect your unit from the mains and reconnect it.
If the problem persists, contact our maintenance department.
SOLUTION