Settings; Transmission Report Codes - Sagem PHONEFAX 320 User Manual

2. SETTINGS

To view the unit's settings, press FUNCTION, 9 and
The user can scroll through the settings by using the > and < navigation keys.
IMP LIST:
TX HEADER:
TX LOCK UP:
ANTI ECHO:
RX HEADER:
RX LOCK UP:
REDUCE MODE:
REDUCE RATE:
NB OF PAGES:
PAUSE LENGTH:

3. TRANSMISSION REPORT CODES

The log (send/receive) and the transmission report detail the outcome of each transmission. In the event of an
incident, they will use one of the following codes:
Code 01 - No answer
Try again later.
Code 03 - STOP
Call interrupted by user pressing STOP.
Code 04 - Invalid speed dial number
Check number.
Code 05 - Document feeder problem during the call
Paper jam or document feeder malfunction.
Code 07 - Bad line or remote terminal malfunction
Try again.
Code 08 - The document sent may not have been received in full
Send again and check with recipient.
Code 0A - Polling operation failed
No fax-back document on remote terminal.
Code 0B - There is a difference between the number of pages logged for sending and the number of pages
actually sent out
Check the number of pages.
Code 13 - Memory full
Fax could not be received.
22
List of settings printing.
Transmit your name, fax number, the date and time to the recipient; the data will be
displayed in the header of the faxes they receive.
Set a ceiling transmission speed for faxes sent to selected numbers in the directory
This setting blocks the satellite echo in the event of quality problems with long-distance
faxing.
Print out the name and fax number of the sender as well as the current date and time on
the headers of incoming faxes.
Maximum receive speed for incoming faxes.
Condensed printing mode (incoming faxes, local photocopies): automatic or manual.
This parameter sets the condensed printing ratio (in automatic condensed mode).
This parameter shows the number of pages printed out (incoming faxes and local copies)
since the unit was plugged in.
Duration of the line break induced by the "Pause" signal emitted by the R key: long or
short.
.